If you have been reading about heptapeptide and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2025-08-21. Numbers and descriptions here follow the published literature rather than marketing material.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. It was developed as a fragment analog of adrenocorticotropic hormone, modeled specifically on the ACTH(4-10) region. The first four residues reproduce that fragment, while a Pro-Gly-Pro tripeptide is appended at the C-terminus. Work on the compound originated in Russia, where it entered clinical use as an intranasal preparation. Its sequence places it among short regulatory peptides studied for effects on the central nervous system rather than on the adrenal axis.
The C-terminal Pro-Gly-Pro extension is not incidental. Proline-rich tails are known to resist several common peptidases, and the published literature attributes the longer half-life of Semax, relative to unmodified ACTH fragments, to this feature. The modification also removes the melanocyte-stimulating and corticosteroidogenic activity that characterizes longer ACTH-derived sequences. Because the molecule is small and hydrophilic, it is typically formulated as an aqueous solution for intranasal or parenteral delivery. Acetylation or amidation at the termini appears in closely related research peptides and shifts the mass by a fixed increment.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Published studies are dominated by animal models of stroke, ischemia, and cognitive impairment, with a smaller number of human trials conducted in Russia. Many of the human reports are small, single-center, and published in Russian-language journals, which limits independent scrutiny. Outcome measures vary between studies and often rely on clinician-rated scales rather than objective biomarkers. Systematic reviews have noted the methodological weaknesses and called for larger, preregistered trials before firm conclusions can be drawn.
Claims about enhanced focus, memory, or mood in healthy people rest mostly on anecdotal reports and community discussion rather than on controlled data. It remains unclear whether any cognitive benefit observed in patients recovering from brain injury would extend to uninjured users. Dose-response relationships, long-term safety, and interactions with other drugs are not well characterized in the peer-reviewed literature. Questions about optimal route of administration and treatment duration likewise remain open.
Semax binds to melanocortin receptors and is thought to influence neuronal survival and plasticity rather than to act through the adrenal axis. Laboratory work has shown increased expression of brain-derived neurotrophic factor and nerve growth factor in treated tissue. Changes in c-Fos, a marker of neuronal activation, have also been reported. Because the peptide is rapidly degraded by peptidases, its effects are generally attributed to downstream signaling cascades rather than to sustained receptor occupancy.
Later generations of the molecule include an N-acetylated form and an amidated form, both marketed online alongside the parent peptide. These variants differ in terminal chemistry and stability, and they are frequently discussed in the same breath even though they have not been compared in controlled trials. Supply outside formal healthcare systems comes largely from laboratories that synthesize peptides to order. Purity and identity of these materials vary widely, and no single body oversees the international trade.
Semax is a synthetic heptapeptide developed in the Soviet Union during the 1980s by researchers at the Institute of Molecular Genetics in Moscow. It was designed as a truncated analog of adrenocorticotropic hormone, retaining only the fragment spanning residues four through ten. Investigators sought a peptide that would preserve the cognitive effects associated with ACTH while eliminating the hormonal stimulation of the adrenal cortex. The compound entered clinical use in Russia during the following decade.
Russian regulatory authorities approved the peptide for nasal administration, and it remains listed in the national pharmacopoeia under several trade names. Documented indications include acute ischemic stroke, transient ischemic attacks, traumatic brain injury, and certain ophthalmological and neurological conditions. Physicians also prescribe it for cognitive complaints in older patients, although the evidence base for that use is thinner. Outside Russia and a few neighboring states, the substance is not an approved medicine and is sold instead as a research chemical.
Routine characterization relies on reversed-phase high-performance liquid chromatography to establish purity and on mass spectrometry to confirm molecular identity. Electrospray ionization and matrix-assisted laser desorption ionization are both used for mass verification. Amino acid analysis and peptide mapping can detect sequence errors. Common impurities include truncated sequences, methionine sulfoxide formed by oxidation, and deamidated products. Chromatograms are usually recorded near 214 nm, where the peptide backbone absorbs, and purity is reported as the percentage area of the principal peak.
Verification of a supplied batch generally combines a certificate of analysis with independent testing, because certificates are self-reported documents. A typical package includes a chromatographic trace, a mass spectrum, and a stated water or counter-ion content. Batch-to-batch consistency matters more than a single purity figure when results are compared across experiments. No single mandatory standard governs research-grade peptide release, so laboratories are expected to define their own acceptance criteria. Residual trifluoroacetate from purification is a frequently overlooked counter-ion.
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. The first four residues correspond to the ACTH(4-10) fragment, while the terminal Pro-Gly-Pro extension was added to improve metabolic stability. Its molecular formula is C37H51N9O10S and its monoisotopic mass is approximately 813.9 Da. The compound is classified as a peptide research chemical and as a registered pharmaceutical product in Russia, but it does not hold marketing approval in the European Union or the United States. Naming conventions vary across supplier catalogs.
Development of the compound took place in the Soviet Union during the 1980s, largely through peptide research groups affiliated with the Shemyakin-Ovchinnikov Institute and Moscow State University. Investigators screened fragments of adrenocorticotropic hormone for activity on the central nervous system while attempting to separate cognitive effects from hormonal ones. The shortened sequence was selected because it retained behavioral activity in animal models without stimulating corticosteroid release. Early publications described the molecule as an ACTH(4-10) analog.
Whereas the biological half-life of estradiol given by intravenous injection is about 0.5 to 2 hours, the biological half-life of oral estradiol has a range of 13 to 20 hours due to the large and long-lasting pool of estrogen conjugates that is formed during first-pass metabolism and that serves to continuously replenish circulating estradiol levels.
ETA's alleged responsibility was definitively called into question when four hours later the minister appeared again to report that a video claiming responsibility for the attack had been found in which an individual appeared who, in Arabic with a Moroccan accent, claimed to speak on behalf of Al-Qaeda. On Sunday, March 14, 2004, the general elections were held. The PSOE won the elections by a simple majority by winning 164 deputies, while the PP was left with 148. A month later José Luis Rodríguez Zapatero was invested as the fifth Prime Minister of democracy.
== Interactions == Heparin-binding EGF-like growth factor has been shown to interact with NRD1, Zinc finger and BTB domain-containing protein 16 and BAG1. HB-EGF biological activities with these genes influence cell cycle progression, molecular chaperone regulation, cell survival, cellular functions, adhesion, and mediation of cell migration. The NRD1 gene codes for the protein nardilysin, an HB-EGF modulator. Zinc finger and BTB domain-containing protein 16 and BAG family molecular chaperone regulator function as co-chaperone proteins in processes involving HB-EGF.
Sources: en.wikipedia.org
NatB acetylates N-terminal proteins starting with methionine (iMet) followed by or amidic amino acids, making the target pool to be MD, ME, MN and MQ. Almost 100% of all the proteins that are target substrates of NatB are N-terminally acetylated, which is a unique feature of NatB compared to other NATs. Finding substrates and proteins that are N-terminally acetylated by NatB has been studied in yeast and humans in order to understand the biological function of NatB. In yeast, lack of N-terminal acetylation activity by NatB has an effect on actin and tropomyosin interactions. The NF-κB subunit p65 has also been proposed to be a target protein in humans, as well as tropomyosin 1. NatB also seems to potentially regulate the Set-COMPASS subunit protein Swd1 by N-terminal acetylation, and therefore NatB could regulate H3K4 methylation together with NatA. NatB might also regulate NAD+ metabolism in yeast, where knockout of nat3Δ (NAA25) and mdm20Δ (NAA20) decreased the levels of the nicotinamide mononucleotide adenylyltransferase (Nmnat) proteins Nma1 and Nma2. NATs belongs to the GCN5 related N-acetyltransferases (GNAT) superfamily. N-terminal acetylation is the process of adding an acetyl group during or after protein synthesis.
== Applications == Affibody molecules can be used for protein purification, enzyme inhibition, research reagents for protein capture and detection, diagnostic imaging and targeted therapy. The second generation of Affibody molecule, ABY-025, binds selectively to HER2 receptors with picomolar affinity. These Affibody molecules are in clinical development for tumor diagnosis. Anti-HER2 Affibody molecule, fused with albumin binding domain (ABD), denoted as ABY-027, labeled with Lutetium-177 provided reduction of renal and hepatic uptake of radioactivity in mice xenografts.. Further preclinical research evaluated an optimised version of the same ABD-fused Affibody, reporting an improved therapeutic effect in combination with trastuzumab. In October 2025, a refined variant of the ABD-fused Affibody molecule targeting HER2, radiolabelled with Lutetium-177, entered clinical trials to assess its safety, biodistribution and tolerability in patients with metastatic breast cancer. Recently, anti-ZEGFR Affibody ZEGFR:2377 labeled with technetium-99m was successfully used to visualize ZEGR expressing tumor in mice xenograft also.
In addition to power and ground, these provide connections for data-in, data-out, clock and sometimes a strobe signal. These are connected in a daisy chain, which allows individual LEDs in a long LED strip light to be easily controlled by a microcontroller. Data sent to the first LED of the chain can control the brightness and color of each LED independently of the others. They are used where a combination of maximum control and minimum visible electronics are needed such as strings for Christmas and LED matrices. Some even have refresh rates in the kHz range, allowing for basic video applications. These devices are known by their part number (WS2812 being common) or a brand name such as NeoPixel. Filament An LED filament consists of multiple LED chips connected in series on a common longitudinal substrate that forms a thin rod reminiscent of a traditional incandescent filament. These are being used as a low-cost decorative alternative for traditional light bulbs that are being phased out in many countries. The filaments use a rather high voltage, allowing them to work efficiently with mains voltages. Often a simple rectifier and capacitive current limiting are employed to create a low-cost replacement for a traditional light bulb without the complexity of the low voltage, high current converter that single die LEDs need. Usually, they are packaged in bulb similar to the lamps they were designed to replace, and filled with inert gas at slightly lower than ambient pressure to remove heat efficiently and prevent corrosion.
The plot of v versus [S] above is not linear; although initially linear at low [S], it bends over to saturate at high [S]. Before the modern era of nonlinear curve-fitting on computers, this nonlinearity could make it difficult to estimate KM and Vmax accurately. Therefore, several researchers developed linearisations of the Michaelis–Menten equation, such as the Lineweaver–Burk plot, the Eadie–Hofstee diagram and the Hanes–Woolf plot. All of these linear representations can be useful for visualising data, but none should be used to determine kinetic parameters, as computer software is readily available that allows for more accurate determination by nonlinear regression methods. The Lineweaver–Burk plot or double reciprocal plot is a common way of illustrating kinetic data. This is produced by taking the reciprocal of both sides of the Michaelis–Menten equation. This is a linear form of the Michaelis–Menten equation and produces a straight line with the equation y = mx + c with a y-intercept equivalent to 1/Vmax and an x-intercept of the graph representing −1/KM.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
The sequence is Met-Glu-His-Phe-Pro-Gly-Pro, a seven-residue peptide. The first four residues correspond to the ACTH(4-10) fragment, and Pro-Gly-Pro is added at the C-terminus. N-acetylated versions also appear in the literature and differ in mass.