This is a working overview of lyophilized powder, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-06-27 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Semax is a synthetic peptide created in the Soviet Union during the early 1980s by researchers working in Moscow. It was built from the short adrenocorticotropic hormone fragment known as ACTH(4-10), and the chain was then extended with three additional amino acids. The resulting molecule was named semax and entered clinical use in Russia in 1994. It is generally described as a nootropic and neuroprotective agent rather than as a hormone analogue.
The parent fragment ACTH(4-10) carries the sequence Met-Glu-His-Phe-Arg-Trp-Gly. Semax replaces the arginine and tryptophan positions with a proline-glycine-proline tail, giving Met-Glu-His-Phe-Pro-Gly-Pro. That change removes residues associated with adrenal stimulation, so the peptide does not drive cortisol release the way full ACTH does. This distinction shapes how the compound is grouped in the literature, where it sits with neuropeptides and peptide neuromodulators rather than with corticosteroids.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
溶液状态的稳定性明显低于冻干粉。肽类在水溶液中可能经历水解、氧化与聚集，其中甲硫氨酸和天冬酰胺等残基常是敏感位点。Semax 含有甲硫氨酸，因此氧化风险相对突出。工作液一般主张现配现用，或冷藏并在数日内用尽。缓冲液种类、pH 和离子强度都会影响降解速率，而关于最佳条件的公开数据并不统一。
常规纯度与身份确认依赖反相高效液相色谱，并辅以质谱测定分子量。氨基酸组成分析可用于验证序列构成，肽图分析则能进一步定位修饰或降解产物。杂质谱通常关注缺失序列肽、截短片段和氧化产物。不同方法的检出限并不相同，因此各实验室报告的纯度数值不宜直接横向比较。
各国监管态度分化明显。俄罗斯按处方药管理，部分东欧国家留有使用记录；欧盟与美国未批准其作为药物上市，市面流通品通常标注为研究用化学品。身份差异意味着标示含量、纯度与无菌性缺少统一核查。体育领域还牵涉反兴奋剂名录，跨境携带则受目的地药品法规约束。
Semax 是人工设计的七肽，序列为 Met-Glu-His-Phe-Pro-Gly-Pro，骨架取自促肾上腺皮质激素片段 ACTH(4-10)。它于二十世纪八十年代在苏联的分子遗传学研究机构内合成。设计目标是保留该片段与注意力和记忆相关的活性，同时剔除促皮质激素释放等内分泌作用。此后俄罗斯将其登记为药品并进入临床使用。
当时的短肽研究普遍关注能否穿越血脑屏障、在低剂量下产生中枢效应，Semax 属于这一路线。鼻内给药是其主要使用方式，俄语文献报道的适应症涵盖缺血性卒中、短暂性脑缺血发作、认知功能减退以及视神经病变。这些研究大多发表在当地期刊上，样本规模与终点设置同西方试验惯例存在差异，国际同行对其临床证据的强度看法不一。
Prokinetic agents (e.g. domperidone) Anti-cholinergic agents (e.g. orphenadrine) Evidence suggests that opioid-inclusive anaesthesia is associated with postoperative nausea and vomiting. Patients with chronic pain using opioids had small improvements in pain and physically functioning and increased risk of vomiting.
== History == The FDA approved cipaglucosidase alfa in combination with miglustat based on evidence from a clinical trial (Trial 1/NCT03729362) of 123 participants with late-onset Pompe disease. Safety data from the use of cipaglucosidase alfa in combination with miglustat was primarily obtained from one clinical trial (Trial 1, NCT03729362). Data from two other trials (Trial 2/NCT02675465 and Trial 3/NCT04138277) were also reviewed for completeness of the safety assessment. The three trials enrolled 151 participants with late-onset Pompe disease. The trials were conducted at 61 sites in 24 countries around the world, including the United States. In Trial 1, 123 adults with late-onset Pompe disease received either cipaglucosidase alfa intravenously once every two weeks for 52 weeks in combination with miglustat, or another medication (called the active comparator) intravenously once every two weeks for 52 weeks in combination with placebo. Of the 123 participants, 95 previously received enzyme replacement therapy, and 28 never received enzyme replacement therapy before the trial. Neither the participants nor the healthcare providers knew which treatment was being given until after Week 52.
Anti-trans actors employ various strategies in their spread of misinformation around transgender health care by inventing pseudoscientific concepts and attacking professionals and organizations that provide gender affirming care, trying to frame gender-affirming care as "dangerous" or "experimental" or claims that a majority of transgender youth will detransition, something scientists have refuted and named the desistance myth, or can be cured using conversion therapy.
Sources: en.wikipedia.org
=== Pharmacodynamics === Metribolone is an AAS, or an agonist of the AR, with both anabolic and androgenic activity. It is one of the most potent AAS to have ever been synthesized, with 120 to 300 times the oral anabolic potency and 60 to 70 times the androgenic potency of the reference AAS methyltestosterone in castrated male rats, although the same level of potency has not been observed in studies in humans. In addition to the AR, metribolone has high affinity for the progesterone receptor (PR), and binds to the glucocorticoid receptor (GR) as well. The drug was also identified in 2007 as a potent antimineralocorticoid, with similar affinity for the mineralocorticoid receptor as aldosterone and spironolactone. In addition, metribolone was identified in 2010 as a potent inhibitor of 3β-hydroxysteroid dehydrogenase (3β-HSD) 1 and 2 (IC50 = 0.02 and 0.16 μM, respectively). On the basis of this finding, it has been said that metribolone should be used very cautiously in scientific research, taking into account 3β-HSD inhibition to avoid erroneous interpretation. Metribolone has a high potential for hepatotoxicity, similarly to other 17α-alkylated AAS. However, the hepatotoxic potential of metribolone appears to be exceptionally high, likely in relation to its very high potency and metabolic stability; in a study of treatment with the drug for advanced breast cancer, severe hepatic dysfunction was observed at very low dosages.
Arsenic trioxideα Asparaginaseα Bendamustineα Bleomycinα Calcium folinate (leucovorin calcium)α Capecitabineα Carboplatinα Chlorambucilα Cisplatinα Cyclophosphamideα Cytarabineα Dacarbazineα Dactinomycinα Daunorubicinα Docetaxelα Doxorubicinα Doxorubicin (as pegylated liposomal)α Etoposideα Fludarabineα Fluorouracilα Gemcitabineα Hydroxycarbamide (hydroxyurea)α Ifosfamideα Irinotecanα Melphalanα Mercaptopurineα Methotrexateα Oxaliplatinα Paclitaxelα Pegaspargaseα Procarbazineα Realgar Indigo naturalis formulationα Tioguanineα Vinblastineα Vincristineα Vinorelbineα
Column chromatography is a separation technique in which the stationary bed is within a tube. The particles of the solid stationary phase or the support coated with a liquid stationary phase may fill the whole inside volume of the tube (packed column) or be concentrated on or along the inside tube wall leaving an open, unrestricted path for the mobile phase in the middle part of the tube (open tubular column). Differences in rates of movement through the medium are calculated to different retention times of the sample. In 1978, W. Clark Still introduced a modified version of column chromatography called flash column chromatography (flash). The technique is very similar to the traditional column chromatography, except that the solvent is driven through the column by applying positive pressure. This allowed most separations to be performed in less than 20 minutes, with improved separations compared to the old method. Modern flash chromatography systems are sold as pre-packed plastic cartridges, and the solvent is pumped through the cartridge. Systems may also be linked with detectors and fraction collectors providing automation. The introduction of gradient pumps resulted in quicker separations and less solvent usage. In expanded bed adsorption, a fluidized bed is used, rather than a solid phase made by a packed bed. This allows omission of initial clearing steps such as centrifugation and filtration, for culture broths or slurries of broken cells. Phosphocellulose chromatography utilizes the binding affinity of many DNA-binding proteins for phosphocellulose.
== Background == The first successful delivery of a drug across the BBB occurred in 1995. The drug used was hexapeptide dalargin, an anti-nociceptive peptide that cannot cross the BBB alone. It was encapsulated in polysorbate 80 coated nanoparticles and intravenously injected. This was a huge breakthrough in the nanoparticle drug delivery field, and it helped advance research and development toward clinical trials of nanoparticle delivery systems. Nanoparticles range in size from 10 - 1000 nm (or 1 μm) and they can be made from natural or artificial polymers, lipids, dendrimers, and micelles. Most polymers used for nanoparticle drug delivery systems are natural, biocompatible, and biodegradable, which helps prevent contamination in the CNS. Several current methods for drug delivery to the brain include the use of liposomes, prodrugs, and carrier-mediated transporters. Many different delivery methods exist to transport these drugs into the body, such as peroral, intranasal, intravenous, and intracranial. For nanoparticles, most studies have shown increasing progression with intravenous delivery. Along with delivery and transport methods, there are several means of functionalizing, or activating, the nanoparticle carriers. These means include dissolving or absorbing a drug throughout the nanoparticle, encapsulating a drug inside the particle, or attaching a drug on the surface of the particle.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Registered medical products are most often 0.1% nasal drops. Research suppliers ship lyophilized powder, usually in milligram quantities, which is dissolved before use. The active peptide is the same in both cases; presentation and excipients differ.